|AN315 nut showing washer face|
The previous article I discussed the purpose of the washer face on the bolt head. AN nuts may also (optional for most nuts) use a washer face. It seems obvious that the seating face should be flat, smooth, and perpendicular (within 2 degrees) to the bolt axis.
So how is this design feature of importance to the mechanic? A lot rides on the integrety of this surface:
Face surface influences the tightening tension produced by your torque wrench by controlling friction. It's estimated that 50% of the friction produced during tightening comes from the bolt head and nut surfaces rather than at the threads.
Nut face angularity influences the fatigue life of the bolt. Angularity or lack of, dramatically reduces the bolt's fatigue life. Bolt Science shows that at 2% angularity (at the edge of allowed limit for a common AN nut) can reduce the bolt's fatigue life from 180,000 fatigue cycles to just 10,000 fatigue cycles!
Nut face surface influences how much embedment relaxation (joint loosening) occurs after you stop torquing the joint. The surfaces squish together slightly resulting in a loss of joint tension. An example of this is the crushed washer below. As the washer surface compresses, the joint becomes loose even though it was properly torqued to begin with.
Now take a look at the nuts below. The malformed washer faces can crush just like the washer and result in a loose joint.
|AN310 Castle Nut with malformed washer face|
Compare the contact area of a normal washer face on the left with this malformed washer face on the right. The malformed face concentrates the tension onto a small ring which is more likely going to gouge and crush into the contact surface.
|Contact face comparison|
|Deep ridges on the washer face caused by a dull cutting tool|
The malformed nuts shown here reduce the joint integrity which may lead to joint failure, which in the aircraft industry is often catastrophic. As I have observed over the years, if the joint fails due to loosening, it will be assumed without any further investigation that the mechanic didn't tighten the joint properly. example, YOU will be blamed. A quick inspection of surfaces: bolt, nut, faying, washers, is recommended before assembly.
and while I am giving recommendations, torque specifications that specify the application of lubricant are defective if they do not also include where to apply the lubricant. Since the seating surfaces represents 50% of the friction during tightening, it's important to know if the engineer intended that these surfaces, and the thread surfaces, be lubricated. The practice varies among engineer's so there is know way of knowing if the specification doesn't state.
Companion article link AN Bolt Head Design